Tip:
Higher Notes (+2 Octave) - When entering a Pattern from a Roland TB-03, to a Beringer TD-3, drop the entire Pattern down 1 Octave. Then, using the "Tuning" / "Tune" dial, pitch the Pattern back up by 1 Octave.
This would only be necessary if the highest note has a +2 Octave.
This tip will only work if the lowest note in the Pattern is a 0 Octave (See Pattern table below).

Lower Notes (-2 Octave) - When entering a Pattern, from a Roland TB-03, to a Beringer TD-3, raise the entire Pattern up 1 Octave. Then, using the "Tuning" / "Tune" dial, pitch the Pattern back down by 1 Octave.
This would only be necessary if the lowest note has a -2 Octave.
This tip will only work if the highest note in the Pattern is a 0 Octave (See Pattern table below).

Patterns that have both +2 Octave notes and -2 Octave notes can't be transferred without transposing these notes to +1 and -1 instead. Obviously, this will sound different to the original pattern.